JLG 600SC Service And Maintenance Manual page 79

SPN
655
655
655
656
656
656
676
676
677
677
677
677
677
677
729
729
729
729
898
975
975
975
1079
1080
1109
1136
1176
1176
1176
1176
1180
1180
1180
1180
1188
1188
1188
1188
1188
1188
1188
1188
1188
3121776
Table 3-1. Deutz Trouble Codes (TD2.9 L4 Engine)
FMI
5 Injector 5 (in firing order); interruption of electric connection
3 Injector 5 (in firing order); short circuit
4 High side to low side short circuit in the injector 5 (in firing order)
5 Injector 6 (in firing order); interruption of electric connection
3 Injector 6 (in firing order); short circuit
4 High side to low side short circuit in the injector 6 (in firing order)
11 Cold start device relay error
11 Cold start aid relay open load
3 Starter relay high side. Short circuit to battery.
4 Starter relay high side short circuit to ground.
5 Starter relay low side no load error.
12 Starter relay power stage over temperature.
3 Starter relay low side short circuit to battery.
4 Starter relay low side short circuit to ground.
5 Cold start aid relay open load
12 Cold start aid relay; over temperature error
3 Intake Air Heater Device; Short circuit to battery
4 Air intake heater; Short circuit to ground error for power stage on CJ945.
9 Timeout Error of CAN-Receive-Frame TSC1TE; Set point
5 PWM-Signal Fan, Open load or short-circuit ground
3 PWM-Signal Fan, short-circuit to plus
4 PWM-Signal Fan, open load or short circuit to ground
13 Failure of sensor supply voltage 1.
13 Failure of sensor supply voltage 2.
2 Engine shut off demand ignored
0 Physical range check high for ECU temperature
0 Pressure sensor upstream turbine, Physical Range Check high.
1 Pressure sensor upstream turbine, Physical Range Check low.
3 Pressure sensor upstream turbine, signal range check (SRC) high.
4 Pressure sensor upstream turbine, signal range check (SRC) low.
3 Sensor error exhaust gas temperature upstream turbine; signal range check high
4 Sensor error exhaust gas temperature upstream turbine; signal range check low
0 Physical range check high for exhaust gas temperature upstream turbine
1 Physical range check low for exhaust gas temperature upstream turbine
11 Wastegate actuator; internal error
11 Wastegate actuator; EOL calibration not performed correctly
13 Wastegate actuator calibration deviation too large, re-calibration required
2 Wastegate; status message from ECU missing
7 Wastegate actuator; blocked
11 Wastegate actuator; over temperature (> 135°C)
11 Wastegate actuator; operating voltage error
7 Turbocharger wastegate, mechanical blocking detected.
2 Turbocharger wastegate, CAN Error
SECTION 3 - CHASSIS & TURNTABLE
Error Identification
3-33