Serial Port Settings - NetModule NB3710 User Manual

NB3710
User Manual for NRSW version 4.4
Running a device server, the following settings can be applied:
HOME INTERFACES
WAN
Link Management
Supervision
Settings
Ethernet
Port Setup
VLAN Management
IP Settings
Mobile
Modems
SIMs
Interfaces
WLAN
Administration
Configuration
IP Settings
Bridges
USB
Serial
Digital I/O
GNSS
NetModule Router Simulator
Hostname NB1600
Software Version 4.4.0.103
© 2004-2020, NetModule AG
Parameter
Physical protocol
Baud rate
Data bits
Parity
Stop bits
ROUTING FIREWALL VPN SERVICES
Administration Port Settings
SERIAL1 Port Settings
Physical protocol:
Baud rate:
Data bits:
Parity:
Stop bits:
Software flow control:
Hardware flow control:
Server Configuration
Protocol on IP port:
Port:
Timeout:
Allow remote control (RFC 2217):
Show banner:
Allow clients from:
Apply
Figure 5.18.: Serial Port Settings
Serial Settings
Selects the desired physical protocol on the serial port
Specifies the baud rate run on the serial port
Specifies the number of data bits contained in each frame
Specifies the parity used for every frame that is transmitted or re-
ceived
Specifies the number of stop bits used to indicate the end of a frame
81
SYSTEM
RS232
115200
8 data bits
None
1 stop bit
None
None
Telnet
2000
endless
numbered 600
everywhere
specify
LOGOUT