Serial Port Settings - NetModule NB3000-Line-Hd User Manual

Running a device server, the following settings can be applied:
Parameter
Physical protocol
Baud rate
Data bits
Parity
Stop bits
Software ow control
Hardware ow control
NB3000-Line-Hd User Manual 4.2
Figure 5.18.: Serial Port Settings
Serial Settings
Selects the desired physical protocol on the serial port
Speci es the baud rate run on the serial port
Speci es the number of data bits contained in each frame
Speci es the parity used for every frame that is transmitted or
received
Speci es the number of stop bits used to indicate the end of a
frame
De nes the software ow control for the serial port, XOFF will
send a stop, XON a start character to the other end to control
the rate of any incoming data
You may enable RTS/CTS hardware ow control, so that the
RTS and CTS lines are used to control the ow of data
71