NetModule NB3710 User Manual page 65

NB3710
User Manual for NRSW version 4.4
Configurable parameters for access-point, client mode, mesh point and any dual mode:
Parameter
Regulatory Domain
Number of antennas
Antenna gain
Disable low data rates
Warning
Please be aware that any inappropriate parameters can lead to an infringement of con-
formity regulations.
Running as access point or dual mode, you can further configure the following settings:
Parameter
Operation type
Radio band
Bandwidth
Channel
Short Guard Interval
Running as client, you can further configure the following settings:
Parameter
Scan channels
2.4 GHz
5 GHz
Available operation modes are:
Standard
802.11a
802.11b
WLAN Management
Select the country the Router operates in
Set the number of connected antennas
Specify the antenna gain for the connected antennas. Please refer to
the antennas datasheet for the correct gain value.
Avoid sticky clients by disabling low data rates.
WLAN Management
Specifies the desired IEEE 802.11 operation mode
Selects the radio band to be used for connections, depending on your
module it could be 2.4 or 5 GHz
Specify the channel bandwidth operation mode
Specifies the channel to be used
Enables the Short Guard Interval (SGI)
WLAN Management
Select if all supported channels should be scanned or just user de-
fined channels
Set the channels which should be scanned in 2.4 GHz
Set the channels which should be scanned in 5 GHz
Frequencies
5 GHz
2.4 GHz
65
Bandwidth
20 MHz
20 MHz
Data Rate
54 Mbit/s
11 Mbit/s