Print Help; Getting Config Parameters - NetModule NB3710 User Manual

NB3710
User Manual for NRSW version 4.4
Key Sequence Action
CTRL-t
Drag the character before point forward moving point forward as well; if point is
at the end of the line, then this transposes the two characters before the point
ALT-t
Drag the word before point past the word after point, moving point over that word
as well. If point is at the end of the line, this transposes the last two words on
the line.
CTRL-k
Delete the text from point to the end of the line
CTRL-y
Yank the top of the deleted text into the buffer at point
Please note, that it can be required to apply quotes (") when entering commands with arguments
containing whitespaces.

6.2. Print Help

The help command can be used to get the list of available commands when called without arguments,
otherwise it will print the usage of the specified command.
> help
Usage :
help [ < command > ]
Available commands :
get
set
done
update
cert
status
scan
send
restart
debug
reset
reboot
shell
help
no autologout
history
exit
6.3. Getting Config Parameters
The get command can be used to get configuration values.
> get h
Usage :
get [ hsvfc ] <parameter > [ < parameter > . . ]
Get config parameters
Set config parameters
Check done
Update system facilities
Manage keys and certificates
Get status information
Scan networks
Send message , mail , techsupport or ussd
Restart service
Debug system
Reset system to factory defaults
Reboot system
Run shell command
Print help for command
Turn off auto logout
Show command history
Exit
192