NetModule NB3710 User Manual page 82

NB3710
User Manual for NRSW version 4.4
Parameter
Software flow control
Hardware flow control
Protocol on TCP/IP
Port
Timeout
Parameter
Protocol on IP port
Port
Timeout
Allow remote control
Show banner
Stop bits
Allow clients from
Please note that the device server does not provide authentication or encryption and clients will be
able connect from everywhere. Please consider to restrict access to a limited network/host or block
packets by using the firewall.
Serial Settings
Defines the software flow control for the serial port, XOFF will send a
stop, XON a start character to the other end to control the rate of any
incoming data
You may enable RTS/CTS hardware flow control, so that the RTS and
CTS lines are used to control the flow of data
You may choose the IP protocols Telnet or TCP raw for the device
server
The TCP port for the device server
The timeout until a client is declared as disconnected
Server Settings
Selects the desired IP protocol (TCP or Telnet)
Specifies the TCP port on which the server will be available
The time in seconds before the port will be disconnected if there is no
activity on it. A zero value disables this function.
Allow remote control (ala RFC 2217) of the serial port
Show a banner when clients connect
Specifies the number of stop bits used to indicate the end of a frame
Specifies which clients are allowed to connect to the server
82