Ipsec Configuration - NetModule NB3710 User Manual

NB3710
User Manual for NRSW version 4.4
Configuration
HOME INTERFACES
OpenVPN
Administration
Tunnel Configuration
Client Management
IPsec
Administration
Tunnel Configuration
PPTP
Administration
Tunnel Configuration
Client Management
GRE
Administration
Tunnel Configuration
L2TP
Administration
Tunnel Configuration
NetModule Router Simulator
Hostname NB1600
Software Version 4.4.0.103
© 2004-2020, NetModule AG
General
For setting up the tunnel you will have to configure the following parameters first:
Parameter
Remote peer
DPD Status
Detection cycle
Failure threshold
ROUTING FIREWALL VPN SERVICES
IPsec Tunnel Configuration
Name Status Type Peer
Tunnel1 enabled psk 194.29.27.204
Figure 5.32.: IPsec Configuration
IPsec General Settings
IP address or host name of the remote IPsec peer. You may specify
0.0.0.0 to act as a responder for roadwarrior clients.
Specifies whether Dead Peer Detection (see RFC 3706) shall be
used. DPD will detect any broken IPSec connections, in particu-
lar the ISAKMP tunnel, and refresh the corresponding SAs (Secu-
rity Associations) and SPIs (Security Payload Identifier) for a faster
re-establishment of the tunnel.
The delay (in seconds) between DPD keepalives that are sent for this
connection (default 30 seconds)
The number of unanswered DPD requests until the IPsec peer is con-
sidered dead (the router will then try to re-establish a dead connection
automatically)
116
SYSTEM
IKE IPsec Local Network Remote Network
aes256- aes256-
sha256 sha256
LOGOUT