Table of Contents
Advertisement
Emergency unlocking or locking of
the driver's door
Fig. 72
Driver door lever: lock cylinder.
If the central locking system should fail to op-
erate, the driver door can still be locked and
unlocked by turning the key in the lock.
As a general rule, when the driver door is
locked manually all other doors are locked.
When it is unlocked manually, only the
driver door opens. Please observe the instruc-
tions relating to the anti-theft alarm system
›››
page 94.
●
Remove the key blade from the vehicle key
›››
page 86.
●
Insert the key blade into the lock cylinder to
unlock or lock the vehicle.
Opening and closing
Doors
Special characteristics
●
The anti-theft alarm will remain active when
vehicles are unlocked. However, the alarm will
›››
not be triggered
page 94.
●
After the driver door is opened, you have 15
seconds to switch on the ignition. Once this
time has elapsed, the alarm is triggered.
●
Switch the ignition on. The electronic immo-
bilizer recognises a valid vehicle key and deac-
tivates the anti-theft alarm system.
Note
The anti-theft alarm is not activated when
the vehicle is locked manually using the key
›››
page 90
shaft
.
Emergency lock of doors without
lock cylinders
Fig. 73
Locking the door manually.
If the central locking system should fail to work
at any time, doors with no lock cylinder will
have to be locked separately.
The emergency lock is located on the front of
the front passenger's door and the rear doors.
It can only be seen if the door is open.
●
If necessary, remove the rubber seal
›››
the front of the door
Fig. 73.
●
Insert the key in the inside slot and turn it to
the right as far as it will go (if the door is on the
right side) or to the left (if the door is on the
left side).
●
Replace the cap.
Once the door has been closed it can no lon-
ger be opened from the outside. Pull the inte-
rior door handle once to unlock and open the
door.
from
97
Advertisement
Table of Contents
