Table of Contents
Advertisement
●
Move the gear lever to position P since oth-
erwise the vehicle cannot be locked.
●
Lock the vehicle using the
button on the
vehicle key.
●
Within 5 seconds, touch the sensor on the
›››
outside of the door handle
Fig. 69
once. Do not grip the handle while doing so.
This temporarily deactivates the Keyless Ac-
cess system.
●
Check that it is deactivated by pulling the
door handle after at least 10 seconds. It should
not be possible to open the door.
The next time, the vehicle can only be un-
locked electronically with the vehicle key. After
being unlocked the next time, the Keyless Ac-
cess system will be activated again
Permanently disabling the Keyless Access
system
The Keyless Access system can also be perma-
nently deactivated in the infotainment system
›››
.
Convenience functions
To close all the electric windows and the sun-
roof using the comfort function, keep a finger
for a few seconds on the locking sensor sur-
›››
face
Fig. 69
of the door handle until the
B
windows and roof have closed.
How the doors open when touching the sen-
sor surface on the door handle will depend on
the settings that have been activated in the
Keyless Access system
Opening and closing
infotainment system, using the function button
> Vehicle > Exterior > Central
locking.
NOTICE
B
Deactivating the Keyless Access system also
deactivates the sensor controlled opening
and closing of the rear lid, although the func-
tion is shown as "active" in the vehicle menu.
Note
● Depending on the function set on the info-
tainment system for the mirrors, the exterior
mirrors will unfold and the surround lighting
will come on when unlocking the vehicle us-
›››
.
ing the sensor surface on the driver and pas-
senger door handles.
● If the vehicle is fitted with an automatic
gearbox, the vehicle can only be locked by
pressing the parking lock button P.
● To improve the safety of your vehicle, the
remote control of the system is equipped
with a position sensor. If this remote con-
trol does not detect movement for a certain
length of time, the system will conclude that
the vehicle cannot be opened (e.g. on a night
table) so it will be disabled.
Troubleshooting
The Keyless Access system does not work
The operation of the sensor surfaces may be
limited if they are very dirty.
●
Clean the sensor surfaces.
All turn signals flash four times
The key that was last used is still inside the
vehicle.
●
Remove the key and lock the vehicle.
Automatic deactivation of the sensor surfa-
ces
The sensor surfaces are deactivated in the fol-
lowing cases:
●
If the vehicle is not unlocked or locked for a
long period of time.
●
If any of the sensor surfaces are activated
unusually often.
To reactivate the sensor surfaces:
●
Unlock the vehicle using the
vehicle key.
button on the
89
Advertisement
Table of Contents
