Table of Contents
Advertisement
Failure warning lamp
4
Charging cable information
Before using the charging cable, also follow the
instructions displayed on it and on the rear of
the protective device.
Protection device
The electronic protection device
ensures that the charging connector does not
receive current until it is plugged in to the vehi-
cle's charging connector.
Self-check
When the charging cable is plugged into the
electrical socket, the protective device au-
tomatically performs a self-test. During this
check, all warning and indicator lamps turn on
briefly and go out one after the other. Upon
completion, the operational status at that time
is displayed.
Operating displays
›››
One or more control lamps
Fig. 62
o
light up green.
3
›››
Fig. 62 Meaning
Display
ignition
The charging cable is
1
plugged into the mains
High-voltage battery
Charging cable
›››
Fig. 62 Meaning
Display
,
on,
1
2
flashes slowly
3
›››
page 83
and
1
2
3
›››
Fig. 62
Set the charging current
The charging cable limits the charging current
according to the available power supply.
If the local mains supply does not allow charg-
ing at the maximum charging current, the
charging current can be reduced, depending
on the charging setting features in the infotain-
›››
ment system
Temperature control
The charging cable temperature control
switches on when the charging cable over-
heats, such as when it has been stored in a lug-
,
1
2
gage compartment exposed to high tempera-
tures or strong sunlight.
›››
Fig. 62 Meaning
Display
,
flashing
1
4
,
flashing
2
4
The high-voltage bat-
tery is charging.
on
The charging process
is complete. The high-
voltage battery has
charged.
page 80.
The housing connector
has overheated.
The protection device
has overheated.
If the charging process continues with a lower
current, both the operating indicator and the
›››
warning lamp
Fig. 62
flash red.
4
●
Unplug the charging cable from the mains
and wait for it to cool down.
●
If it disconnects again, or the charging cur-
rent reduces and the cause does not seem to
be exposure to an external heat source, make
sure that the green control lamp is flashing
›››
Fig. 62. Visit a specialised CUPRA dealer or
any SEAT network dealer to check the charg-
ing cable. Get an establishment that special-
ises in electrical installations to check the in-
frastructure connection.
Fault display
If the red warning light
flashes or turns on
4
without one of the indicator lamps
,
o
also turning on continuously on the
1
2
3
status indicator, there is a fault.
›››
Fig. 62 Meaning
Display
flashing,
on
Failure in the power
1
4
or flashing
supply.
flashing,
on
Failure in the protection
2
4
or flashing
device.
flashing,
on
Failure in the vehicle.
3
4
or flashing
The charging process pauses or is cancelled.
›››
Fig. 62
83
Advertisement
Table of Contents
