Table of Contents
Advertisement
●
The tyre mobility set is intended for tem-
porary emergency use only until you can
reach the nearest specialised workshop.
●
Replace the repaired tyre with the tyre mo-
bility set as soon as possible.
●
The sealant is a health hazard and must be
cleaned immediately if it comes into contact
with the skin.
●
Always keep the tyre mobility set out of the
reach of small children.
WARNING
A tyre filled with sealant does not have the
same performance properties as a conven-
tional tyre.
●
Never drive faster than 80 km/h (50 mph).
●
Avoid heavy acceleration, hard braking and
fast cornering.
●
Drive for only 10 minutes at a maximum
speed of 80 km/h (50 mph) and then check
the tyre.
For the sake of the environment
Dispose of used or expired sealant observing
any legal requirements.
Note
You can purchase a new bottle of tyre seal-
ant in specialised CUPRA dealers or any SEAT
dealership.
Wheels and tyres
Tyre repair
Note
Take into account the separate instruction
manual provided by the tyre mobility system
manufacturer.
Anti-puncture kit contents
Fig. 237
Standard display: contents of the
anti-puncture kit.
The anti-puncture kit is located underneath
the floor covering in the luggage compart-
ment. Includes the following components
›››
Fig. 237:
Valve insert remover
1
A sticker to be adhered to the instrument
2
cluster, within the driver's visual field, to
remind that the maximum advisable speed
"max. 80 km/h" or "max. 50 mph"
Filler tube with cap
3
Air compressor (depending on the version,
4
the model may vary).
ON/OFF switch
5
Air bleed screw (it can also be integrated in
6
the inflator tube).
Warning provided by tyre pressure moni-
7
toring system (it can also be integrated in
the inflator tube).
Tube for inflating tyres
8
12 volt connector
9
Bottle of sealant
10
Spare tyre valve
11
The valve insert remover
has a gap at the
1
lower end for a valve insert. The valve insert
can only be screwed or unscrewed in this way.
This also applies to its replacement part
Sealing and inflating a tyre
Sealing the tyre
●
Unscrew the tyre valve cap and insert. Use
›››
the device
Fig. 237
to remove the valve
1
cap. Place it on a clean surface.
●
Shake the tyre sealant bottle vigorously
›››
Fig. 237
.
10
›››
●
Screw the tyre inflation hose
into the tyre sealant bottle. The bottle's seal
will break automatically.
.
11
Fig. 237
3
349
Advertisement
Table of Contents
