Table of Contents
Advertisement
65 mm (minimum)
B
350 mm to 420 mm (fully laden vehicle)
C
1,043 mm
D
344 mm / 333 mm (PHEV)
E
564 mm / 553 mm (PHEV)
F
887 mm (Leon) / 876 mm (Leon
G
PHEV) / 1162.5 mm (Leon Sportstourer) /
1154 mm (Leon Sportstourer PHEV)
CUPRA recommends that towing brackets be
retrofitted at a specialised workshop. For ex-
ample, it may very well be necessary to adjust
the cooling system or mount thermal protec-
tion plates. To do so, CUPRA recommends go-
ing to a specialised CUPRA dealer or any SEAT
dealership.
If a towing bracket is retrofitted, the distance
specifications should always be kept in mind.
The distance between the centre of the ball
›››
head and the road
Fig. 198
be less than that indicated. This also applies
when the vehicle is fully loaded, including the
technically permissible maximum vertical load
on the coupling device.
296
WARNING
If the cables are improperly or incorrectly
connected, this may lead to malfunctions in
the entire vehicle electronic system, as well
as to accidents and serious injuries.
●
Never connect the trailer's electric sys-
tem to the electrical connections of the tail
lights or any other unsuitable power sources.
Only use suitable connectors to connect the
trailer.
●
The towing bracket should be retrofitted
only at a specialised workshop.
WARNING
If the towing bracket is badly fitted or unsuit-
able, the trailer may separate from the vehi-
cle while driving. This could cause serious ac-
cidents and fatal injuries.
must never
C
Note
● According to regulation EU2021_535 it is
not permitted to install a towing device that
cannot be removed or retracted.
● Only use towing brackets that have been
approved by CUPRA for the model in ques-
tion.
● In some versions, the fitting of a conven-
tional towing hook solution is not recom-
mended. Please consult your Technical Serv-
ice.
Storing objects
Advertisement
Table of Contents
