Table of Contents
Advertisement
›››
the luggage compartment side
The rings for retaining the Top Tether belt are
marked with an anchor symbol.
●
Support bracket: some child seats rest on
the floor of the vehicle with a support bracket.
The support bracket prevents the child seat
from tipping forward in the event of impact.
Child seats fitted with a support bracket should
only be used in the passenger seat and side
›››
rear seats
. For the assembly of this type
of seat you should also consult the list of ap-
proved vehicles for this assembly, available in
the instructions for child restraint systems.
Recommended systems for attaching child
seats
CUPRA recommends attaching child seats as
follows:
●
Baby carriers or child seats in the oppo-
site direction of travel: ISOFIX and support
bracket or i-Size.
●
Child seats in the direction of travel: ISOFIX
and Top Tether.
WARNING
Incorrect use of the support bracket can
cause serious or fatal injury.
●
Make sure the support bracket is correctly
and safely installed.
●
When the base of the child seat is sup-
porting the child's weight, the support foot
should not hang in the air or be supplemen-
Transporting children safely
page 64.
ted with objects. In addition, make sure that
the base of the child seat is always supported
by the surface of the vehicle's seat. The sup-
port leg of the child seat should not raise the
base of the child seat off the surface of the
vehicle's seat.
Securing the child seat with the
ISOFIX or i-Size system
The marking of ISOFIX or i-Size anchor points
depends on the equipment and the country in
question.
See the following tables to understand the
compatibility of the ISOFIX/i-Size systems in
the vehicle:
Safety
61
Advertisement
Table of Contents
