Table of Contents
Advertisement
sensors located below the rear bumper (Easy
›››
Open
page 101). The rear lid will open
automatically.
Closing the rear lid
●
Briefly press the
button on the rear lid
›››
›››
Fig. 76,
in Introduction on
●
EITHER: pull the
button on the driver
›››
door upwards
Fig. 77.
●
OR: on vehicles with Keyless Access, press
and hold the
vehicle key button until the
rear lid is closed or move one foot in the area
of the sensors located below the rear bumper
›››
(Easy Open
page 101). The vehicle key
must be in the Keyless Access system detec-
tion zone at the rear outside the vehicle.
●
OR: manually move the rear lid in the direc-
tion of closing until it closes automatically.
●
The rear lid goes down automatically to the
final position and also closes automatically
›››
in Introduction on
Interrupting opening or closing
After beginning to open or close the rear lid,
the action can be halted by pressing one of the
buttons
.
If you press one of the
rear lid will move again in the original direction.
100
If the rear lid meets with resistance or an ob-
stacle during the automatic opening or closing,
opening or closing will be interrupted imme-
diately. For the closing process, the rear lid
opens again slightly.
●
Check why it has not been possible to open
or close the rear lid.
page 98.
●
Try to open or close the rear lid again.
●
If necessary, the rear lid can be opened or
closed by hand using reasonable force.
Particular features if towing a trailer
If the factory-fitted towing bracket is electri-
cally connected to a trailer
electric rear lid can only be opened or closed
with the buttons on the rear lid itself or by us-
ing the Easy Open function.
Audible warnings
Throughout the process of opening or clos-
ing the rear lid, acoustic warnings can be
page 98.
heard. Exception: when the rear lid is opened
manually using the handle or the Easy Open
function with the movement of the foot or
closed using the button on the rear lid itself
›››
Fig. 76.
buttons again, the
Modifying and memorising the opening an-
gle
If the space behind or above the vehicle is less
than the travel area of the rear lid, you can
change the opening angle of the rear lid.
Opening and closing
›››
page 286, the
To memorise a new opening angle, the rear lid
must be open at least halfway.
●
Interrupt the opening process in the desired
position.
›››
●
Press the
Fig. 76
button on the rear lid
for at least 3 seconds.
The opening angle is memorised. Memorisa-
tion is indicated by blinking of the hazard warn-
ing lights and an audible warning.
Resetting and memorising the opening an-
gle
For the rear lid to reopen completely, the
opening angle must be reset and memorised
again.
●
Release the rear lid and open it to the mem-
orised height.
●
Lift the rear lid by hand as far as it goes. To do
this, some force will have to be used.
›››
●
Press the
Fig. 76
button on the rear lid
for at least 3 seconds.
●
This resets and memorises the factory-set
opening angle. Memorisation is indicated by
blinking of the hazard warning lights and an
audible warning.
Automatic protection against overheating
If the system is operated repeatedly in a short
space of time, it automatically switches off to
prevent overheating.
Advertisement
Table of Contents
