Table of Contents
Advertisement
WARNING
Remove the rear headrests only when it is
necessary to fit a child seat. After removing a
child seat, refit the headrest immediately.
Seat functions
Memory function
Fig. 95
On the outer side of the driver
seat: memory buttons.
Memory buttons
The memory buttons can be used to save and
turn on settings for the driver seat and the ex-
terior mirrors.
The settings will also be saved in the user of
the online
services.
1)
1)
Not available in all markets.
Seats and head restraints
Seat functions
Save the settings of the driver seat and the
exterior mirrors while driving forward
●
Apply the electronic parking brake.
●
Move the gearshift to the neutral position.
●
Switch the ignition on.
●
Adjust the driver seat and the exterior mir-
rors.
●
Press
for longer than 1 second
●
Press the memory button in which to store
the settings within approx. 10 seconds. A warn-
ing sound will confirm they have been stored.
Storing the passenger rear view mirror set-
tings while driving in reverse
●
Apply the electronic parking brake.
●
Move the gearshift to the neutral position.
●
Switch the ignition on.
●
Press the required memory button.
●
Select reverse gear.
●
Adjust the front passenger exterior mirror so
that you can see, for example, the kerb edge
well.
●
The new position of the mirror will be stored
automatically and allocated to the vehicle key
that was used to unlock the vehicle.
Activating settings
●
With the vehicle stopped and the ignition
switched on, press and hold the correspond-
ing memory button until the saved position is
reached.
●
OR: With the ignition switched off and the
driver's door open, briefly press the corre-
sponding button.
›››
Fig. 95.
The front passenger side exterior mirror auto-
matically changes from the position stored for
reversing as soon as the vehicle moves forward
at a speed of at least 15 km/h (10 mph) or
when the gear selection lever is changed to a
position other than R
Initialising the seat position memory
The position memory system must be restar-
ted if, for example, the driver seat has been
changed.
Restarting deletes all memories and assign-
ments for the seat with position memory. The
memory keys can then be programmed again.
●
Open the driver door and do not get into the
vehicle.
●
Operating the seat settings from outside the
vehicle.
●
Tilt the backrest fully forward.
●
Release the control to set the angle and then
press again until an audible warning is heard.
›››
page 129.
115
Advertisement
Table of Contents
