Seat CUPRA LEON 2022 Owner's Manual page 81

Table of Contents

Advertisement

Manual release of the charging connector
The puller for the manual release mechanism
is on the left hand side of the engine compart-
ment, above the charging socket
Disconnect the power supply at the charging
station or electrical socket.
Open the bonnet and make sure it is held in
place with the prop.
››› 
Pull the puller
Fig. 59.
Immediately unplug the charging connector.
WARNING
If the charging connector unexpectedly re-
mains locked, the fault may be caused by the
vehicle or charging station.
The manual emergency release can make live
contacts accessible. In this case, touching
the contacts of the charging socket may re-
sult in burns, other injuries or a fatal electric
shock.
Never touch the contacts of the charging
socket or the charging connector.
Note
The manual release mechanism of the charg-
ing connector should only be used in the
event of a failure.
Charging settings in the infotainment system
High-voltage battery
Note
After using the charging connector's man-
ual release mechanism, the charging socket
››› 
Fig. 59.
must be inspected immediately by a profes-
sional.
Charging settings in the
infotainment system
Battery Manager Menu
✓ Valid for: hybrid vehicles
The Battery Manager allows you to set or
select departure times for the programmed
charging of the high-voltage battery and for
the vehicle's electric heating and air condi-
tioning.
Open the Battery Manager menu
Switch the ignition on.
Switch on the infotainment system.
Select Battery Manager from the main
menu.
It is possible to change the settings for imme-
diate charging (the next charging process).
Reduce the charging current, e.g. when
other major consumers are operating on a sin-
gle line of the electrical installation at the same
time. Charging power is reduced and charging
time is extended.
Set the desired temperature for the inde-
››› 
pendent air conditioning
page 141.
Departure time settings menu
Programmed charging (departure times) can
››› 
be set
page 80.
Specify the amount of time for which you
want the high-voltage battery to charge and
the air conditioning to be switched on inside
the vehicle.
Extended independent air conditioning
menu
Set the desired temperature for the inde-
››› 
pendent air conditioning
page 141.
Warm the seats and windscreen for depar-
ture: select the seats in the Infotainment sys-
tem or switch on windscreen heating. The
active functions will be switched on during
stationary air conditioning (either due to an
immediate start or departure scheduling) if
considered necessary by the air conditioning
(cold conditions).
79

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cupra sportstourer 2022

Table of Contents