Table of Contents
Advertisement
›››
●
Remove the filler cap
screw the open end of the tube into the tyre
valve.
●
With the bottle upside down, empty all of
the contents into the tyre.
●
Remove the bottle from the valve.
●
Replace the howitzer with the device
›››
Fig. 237
onto the tyre valve.
1
Inflating the tyre
●
Screw the tyre inflation tube of the compres-
›››
sor
Fig. 237
on the tyre valve.
8
●
Check that the air evacuation screw is
›››
closed
Fig. 237
.
6
●
Start the engine and leave it running.
›››
●
Attach the connector
vehicle's 12 volt power outlet
●
Switch on the air compressor with ON/OFF
›››
switch
Fig. 237
.
5
●
Keep the air compressor running until it
reaches a pressure of 2.0-2.5 bar (29-36 psi/
200-250 kPa). A maximum of 8 minutes.
●
Disconnect the air compressor.
●
If it does not reach the pressure indicated,
unscrew the tyre inflator tube from the valve.
●
Move the vehicle 10m so that the sealant is
distributed throughout the tyre.
●
Screw the compressor tyre inflator into the
valve.
●
Repeat the inflation process.
350
●
If it still does not come up to pressure, the
Fig. 237
and
3
tyre is too badly damaged. Stop and seek assis-
tance from authorised personnel.
●
Disconnect the air compressor. Unscrew the
tyre inflation tube from the tyre valve.
●
When the tyre pressure is between 2.5 and
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
●
Attach the sticker
strument panel display, within the driver's field
of vision.
●
Check the pressure again after 10 minutes
›››
page 350.
WARNING
When inflating the wheel, the air compressor
Fig. 237
to the
9
and the inflator tube may become hot.
›››
page 228.
●
Protect hands and skin from hot parts.
●
Do not place the hot flexible inflator tube
or hot air compressor on flammable material.
●
Allow them to cool before storing the de-
vice.
●
If it is not possible to inflate the tyre to at
least 2.0 bars (29 psi / 200 kPa), the tyre is
too badly damaged. The sealant is not in a
good condition to seal the tyre. Do not con-
tinue driving. Seek specialist assistance.
Wheels and tyres
›››
Fig. 237
to the in-
2
NOTICE
Switch off the air compressor after a maxi-
mum of 8 operational minutes to avoid over-
heating! Before switching on the air com-
pressor again, let it cool for several minutes.
Check after 10 minutes of driving
›››
Screw in the inflator tube
Fig. 237
and check the pressure on the gauge
1.3 bar (19 psi / 130 kPa) and lower:
●
Stop the vehicle! The tyre cannot be sealed
sufficiently with the tyre mobility set.
●
You should obtain professional assistance
›››
.
1.4 bar (20 psi/140 kPa) and higher:
●
Set the tyre pressure to the correct value
again.
●
Carefully resume your journey until you
reach the nearest specialised workshop with-
out exceeding 80 km/h (50 mph).
●
Have the damaged tyre replaced.
again
8
.
7
Advertisement
Table of Contents
