Seat CUPRA LEON 2022 Owner's Manual page 129

Table of Contents

Advertisement

Note
● When the vehicle stops while the wiper is
on, the wiper switches to operating tempora-
rily at the next lower wiping level.
● If the driver's or passenger door is opened
when the vehicle is stationary, the wipers re-
turn to the starting position and are switched
off. If the door is closed or the wiper lever is
moved within a few seconds, the wiper turns
on again.
● In winter, the service position of the wipers
can be useful to make it easier to lift the wip-
ers off the windscreen when the vehicle is
››› 
page 304
going to be left stationary
Wiper functions
Automatic rear window wipe
The rear wiper switches on automatically when
the wiper is switched on and reverse gear is en-
gaged. The automatic rear window wiper acti-
vation when engaging reverse gear can be acti-
vated and deactivated in the infotainment sys-
tem, in the vehicle settings menu
Note
The windscreen will be wiped again approx-
imately 5 seconds after the windscreen
washer has been activated, provided the ve-
hicle is moving ("drip" function). If you acti-
vate the wipers less than 10 seconds after
the "drip" function, a new wash sequence will
Windscreen wiper and rear window wiper systems
begin without performing the last wipe. For
the "drip" function to work again, you have to
turn the ignition off and then on again.
Note
The wiper will try to wipe away any obstacles
that are on the windscreen. The wiper will
stop moving if the obstacle is still blocking its
path. Remove the obstacle and switch on the
wiper again.
Rain and light sensor
.
››› 
page 36.
Fig. 104 
Windscreen wipers lever: adjust
the rain sensor
Visibility
.
A
Fig. 105 
Rain sensor sensitive surface
The rain sensor controls the frequency of the
windscreen wiper intervals, depending on the
››› 
amount of rain
.
Push the lever to the desired position
››› 
Fig. 104.
Rain sensor off.
0
Rain sensor on; automatic wipe if neces-
1
sary.
Setting sensitivity level of rain sensor:
A
– Set control to the right: high sensitivity.
– Set control to the left: low sensitivity.
When the ignition is switched off and then
back on, the rain sensor stays on and starts
operating again when the windscreen wipers
››› 
are in position
Fig. 104
and the vehicle
1
is travelling at more than 16 km/h (10 mph).
127

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cupra sportstourer 2022

Table of Contents