Table of Contents
Advertisement
NOTICE
Incorrect handling of the net partition could
cause damage.
●
Do not release the net partition when low-
ering it, as the net and other vehicle parts
could be damaged. Roll down the net parti-
tion by hand.
Net partition with the rear seat
backs folded down.
Valid for: Leon Sportstourer
Fig. 183
Assembling the net partition in
the rear seat backrests.
280
Storing objects
Fig. 184
In the boot: net partition hooked
into the rear seat backrests.
Fitting the net partition
●
Fold the rear seat backrests forward.
●
Remove the net partition from the side sup-
ports.
●
Place the net casing in the rail slots in the
›››
direction of the arrows
Fig. 183
●
Push the casing towards the left side of the
vehicle in the direction of arrow
and as far as it will go.
●
Check that the net is secure.
Pulling out and securing the net partition
●
Pull up handle
net from the casing
●
Hook in the net partition on the right or left
›››
side
Fig. 184
●
Hook in the net partition into the housing on
the other side
rod.
The net partition is properly assembled when
the T-shaped ends are firmly secured in the
corresponding housings
.
1
Retracting the net partition
●
Remove the rod from the housings in the
trims of the roof side members.
●
Roll up the net into the casing
lowering it with your hand.
Removing the net partition
.
1
●
Pull the net casing out approximately 5 cm in
the opposite direction to the arrow
›››
Fig. 183
2
.
2
●
Remove the casing from the rails by pull-
ing in the opposite direction to the arrows
›››
Fig. 183
1
●
Lift the rear seat backrests.
›››
Fig. 184
to remove the
2
.
4
(magnified image).
3
›››
Fig. 184
by pulling the
1
›››
Fig. 184
and
3
›››
Fig. 184
4
›››
Fig. 183
.
Advertisement
Table of Contents
