Table of Contents
Advertisement
Yellow line: pre-calculated direction of the
trailer hitch depending on how the steering
wheel is turned.
Cross traffic
This view helps to monitor traffic behind the
vehicle and can be used, for example, when
exiting garages or narrow exits.
Angle parking
Fig. 154
Display on the infotainment
system screen: parking with the reverse
assistant.
›››
Key to the
Fig. 154:
Finding a parking space
222
Parking and manoeuvring
Go to the selected parking space
Centre the vehicle inside the parking
space
Road
1
Parking space
2
Lateral boundary of the parking space
3
Rear boundary of the parking space
4
Parking
●
In the infotainment system select
tants > Parking aid before passing in front of
the selected parking space.
●
With reverse assist connected and in working
order, press the function button
●
Stop the vehicle in front of the parking space
›››
Fig. 154
.
2
●
Reverse while turning the steering wheel so
that the yellow lines enter the parking space.
The green and yellow lines must match the
side boundary lines
.
3
●
Stop the vehicle when the red line has
reached the rear boundary
4
Troubleshooting
The system behaves differently than expec-
ted
There can be several causes:
●
The camera is dirty
tion to dirt and snow, camera visibility can be
reduced by detergent residue or any type of
coating.
●
The system requirements must be met
›››
page 220.
●
The camera is covered with water.
●
The factory-fitted towing bracket must
not be electrically connected to a trailer
›››
page 286.
> Assis-
●
The vehicle has some type of damage in the
camera area, e.g. due to a parking impact.
●
The field of view of the camera is blocked by
an accessory, e.g. a bicycle carrier system.
.
●
Changes have been made to the paint in the
camera area, or structural modifications have
been made to a component such as the run-
ning gear.
Camera with no visibility, fault message, the
system disconnects
●
Clean the camera or remove possible adhe-
sives or accessories from it
.
●
Check for visible damage.
Possible solution
●
Temporarily disconnect the system.
●
Check if one of the causes indicated above
has occurred.
›››
page 356. In addi-
›››
page 356.
Advertisement
Table of Contents
