Table of Contents
Advertisement
Note
● There are different instrument panels and
therefore the versions and instructions on
the display may vary. In the case of displays
without warning or information texts, faults
are indicated exclusively by the control warn-
ing lamps.
● Some indications on the instrument panel
screen may be concealed by a sudden event,
e.g. an incoming call.
● Depending on the equipment, some set-
tings and instructions can be carried out or
displayed on the infotainment system as well.
● If there are several warnings at the same
time, the symbols will be displayed one after
the other for a few seconds. The symbols will
stay on until you remove the cause.
● If when switching on the ignition warnings
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. In this case,
go to a specialised workshop and request a
repair.
Driving data indicator
The driving data display shows a range of driv-
ing data and consumption values.
Change from one display to another
●
Turn the right thumbwheel of the multifunc-
›››
tion steering wheel
page 31.
Driver information
Instrument panel
Changing memory
●
Depending on the view, select Driving
data and press the left arrow or the
on the multifunction steering wheel.
–
Since start: The memory is deleted if
the journey is interrupted for more than 2
hours.
–
Since refuel: Display and storage of
the journey data and the consumption val-
ues collected. When refuelling, the mem-
ory is deleted.
–
Long-term: This memory contains travel
data up to a maximum of 19 hours and
59 minutes or 99 hours and 59 minutes, or
up to a maximum of 1999.9 km or 9999.9
km. When one of these values is exceeded
(varies depending on the version of the
instrument panel), the memory is deleted.
Delete journey data presets
●
Select the memory that you wish to erase.
●
Keep the
button on the multi-function
steering wheel pressed for approximately 2
seconds.
Select the instructions
On the instrument cluster, it is selected man-
ually using the
button on the multifunction
steering wheel. To access the contents of the
tube, rotate the right hand thumbwheel up/
down.
–
Current consumption: The current
fuel consumption display operates
throughout the journey, in litres/100 km;
button
and with the engine running and the vehi-
cle stopped, in litres/hour.
–
Average consumption: The average
fuel consumption is displayed after driving
for approximately 300 metres.
–
Travelling time: This indicates the
hours (h) and minutes (min) since the igni-
tion was switched on.
–
Range: Approximate distance in km that
can still be travelled if the same driving
style is maintained.
–
Distance travelled: Distance covered
in km (m) after switching on the ignition.
–
Average speed: The average speed will
be shown after driving for approximately
100 metres.
–
Boost/Torque: Indicates the power and
torque of the combustion engine (does
not indicate electric mode).
–
FAS: Reduced assistant indication.
Oil temperature display
The engine reaches its operating temperature
when, under normal driving conditions, the
oil temperature is between 80°C (176°F) and
120°C (248°F). If a great effort is required from
the engine and the outside temperature is
high, the engine oil temperature may increase.
23
Advertisement
Table of Contents
