Table of Contents
Advertisement
●
Open the driver's door. If the vehicle is fitted
with an anti-theft alarm, it will trigger immedi-
›››
ately
page 94.
●
Switch the ignition on. Please note: to turn
on the ignition, place the vehicle key at the
bottom of the central armrest box, as close as
possible to the Kessy logo .
This completes the synchronization.
Keyless Access system
Locking and unlocking with the
Keyless Access system
Fig. 68
Keyless Access: proximity zones.
88
Opening and closing
Fig. 69
Driver door lever: sensor surfaces.
›››
Fig. 69
Unlocking sensor surface on the inside of
A
the door handle.
Locking sensor surface on the outside of
B
the door handle.
Depending on the equipment, the vehicle may
have the Keyless Access system. This is a key-
less locking and starting system that can un-
lock and lock the vehicle without actively using
its key. For this, it is only necessary that there
is a valid vehicle key in the detection area cor-
responding to the attempted access to the ve-
hicle.
Configuring the Keyless Access system
The behaviour of the Keyless Access system
can be adjusted in the Vehicle settings menu
›››
of the Infotainment system
page 36.
If the Keyless Access function is disabled, its
operation is limited.
Unlock the vehicle
●
Touch the sensor surface on the inside of the
handle
. All turn signals flash twice.
A
If selective opening is fitted, touching the sen-
sor's surface twice unlocks the entire vehicle.
If the vehicle is not unlocked for an extended
period, the function is deactivated. The func-
tion will reactivate the next time that the vehi-
cle is unlocked with the remote control.
Lock the vehicle
●
Park the vehicle.
›››
●
Touch the sensor surface
the outside of the door handle. All turn signals
flash once.
To check that the vehicle is properly locked,
the unlocking function is deactivated for a few
seconds.
Unlocking the rear lid
When the vehicle is locked, the rear lid auto-
matically unlocks when it is opened if there is
a vehicle key in its proximity zone. The rear lid
locks again after closing.
Temporarily deactivating the Keyless Access
system
The "Keyless Access" system's unlocking func-
tion can be temporarily deactivated:
Fig. 69
on
B
Advertisement
Table of Contents
