Table of Contents
Advertisement
5 – Operating Software
❐
The System Recovery Procedure deletes all existing data files, such as log
files, from the SDC10, and these files cannot be recovered. Back up your data
files to external media before you carry out this procedure.
5.7.1 Required equipment
To perform the System Recovery Procedure you need:
❐
The Teledyne TSS SDC10 recovery USB pen drive (memory stick). This is in addition to the
USB pen drive for software installation (see
37).
❐
A USB Keyboard (not supplied).
5.7.2 Recovery procedure steps
Make sure you have backed up all your data files to external media before you carry out this
procedure.
1. Close down the SDC10 by disconnecting the power cable.
2. Remove the USB port dust cover caps on the front of the Panel PC and attach the Teledyne
TSS SDC10 recovery USB pen drive and a USB keyboard.
3. Hold down the F11 key on the keyboard and reconnect power to the SDC10. If the Unit does
not restart automatically press the Power On-Off button located on the underside of the base
of the Panel PC
The Power On-Off button is not easily accessible when the Panel PC is being
operated from its transit case.
5-32
(Figure
5-17).
© Teledyne TSS
section 5.9 "PC Software Installation" on page 5-
NOTE
DPN 402196 Issue 4.1
Advertisement
Table of Contents
