Table of Contents
Advertisement
Connection" beginning on page B-6 for details of the special electrical connection requirements
necessary to support this communication arrangement.
Where necessary, you may use 4-wire or RS232 communications instead.
Note that, in a Dualtrack System, you must connect the altimeter only to the ALTIMETER port of the
440 SEP, or to an SDC serial port. Do not connect the altimeter to the 350 or 350 Powertrack SEP.
4 Operation
In a Dualtrack installation, you cannot operate the 440 and the 350 or 350 Power-
track Systems simultaneously.
DeepView for Windows allows you to switch between the 440 and the 350 / 350 Powertrack operating
mode easily and quickly. The Run Window and its status bar will show the current operating mode.
5 Power requirement
See
section B.1.7 "Power Supply Requirement" on page B-11
requirements for the sub-sea components of the Dualtrack System.
B.1.3 Scope of Delivery
Dualtrack includes the following major sub-assemblies:
Figure B-1: Surface Display Computer (SDC10)
DPN 402196 Issue 4.1
NOTE
for details of the power supply
© Teledyne TSS
B – Options
B- 3
Advertisement
Table of Contents
