Table 4-8: Sep Link Header Part Numbers - Teledyne 440 System Manual

The header pins are thin and you might damage them if you handle the link care-
lessly.
Align the pins of the replacement header with the receptacles in the socket. The socket has a corner
cut off to ensure that the orientation is correct as shown in
into position until it seats properly in the socket. Check that none of the pins have become bent or
damaged and that all are inserted fully into the socket.
Each of the headers has a different Teledyne TSS part number and establishes a different
communications protocol. You may order a complete set of SEP headers from Teledyne TSS if you
need to change the communication method.

Table 4-8: SEP link header part numbers

SEP Link
LK5
LK4
Once you have set both links, follow the instructions in
page 9-6 to re-assemble the SEP.
DPN 402196 Issue 4.1
NOTE
Table 4-8
2-wire Current-loop
465002
465010
© Teledyne TSS
4 – Electrical Installation
Figure 4-4. Press the link header carefully
lists the part numbers for the SEP headers.
4-wire Current-loop
465008
465011
section 9.2.2.1 "Sub-sea Electronics Pod" on
3-wire RS232
(Standard fit)
465005
465004
4- 13