Table of Contents
Advertisement
3 – Physical Installation
❐
Do not subject the SDC to extremes of temperature or humidity, or to severe vibration or elec-
trical noise. Never allow the SDC to become wet.
Obey the environmental limits listed in section 8.1.1 "Surface Display Computer"
on page 8-2 when you store and operate the SDC.
Operation from transit case
Figure 3-1: SDC10 transit case - lid removal
For temporary installations, operation from the transit case is probably the most suitable method.
Follow the instructions below to correctly install the SDC10:
1. Verify the installation location SDC allows easy access to the touch-screen display and allows
the user to see the screen easily while operating the ROV.
2. Open the four fixings located on the front and rear of the transit case.
3.
Secure the transit case so that it cannot slide or fall with movements of the vessel.
3-2
NOTE
© Teledyne TSS
DPN 402196 Issue 4.1
Advertisement
Table of Contents
