The Equipment; The Differences - Teledyne 440 System Manual

B – Options
B.1.1 The Equipment
The Dualtrack equipment described in this sub-section consists of the following:
❐
Sub-sea components of a Teledyne TSS 440 Pipe and Cable Survey System.
❐ Sub-sea components of a Teledyne TSS 350 or 350 Powertrack Cable Survey Systems.
❐
A single SDC to provide configuration, control and communications functions for both sets of
sub-sea components.
❐ Product Manuals, interconnection cables and mounting components for all three sub-sea elec-
tronics pods.
The 350 requires to have the latest firmware (version 3.7 or later) EPROM. This
can be confirmed in the terminal mode of DeepView for Windows, when the Sys-
tem is initiated a banner is displayed that will identify the version number.
Teledyne TSS supplies the System with Microsoft Windows 7 and the DeepView for Windows graphical
display software already installed and configured to run automatically when you power-on the SDC.
DeepView for Windows can operate in all modes necessary to use the Dualtrack System.
The sub-sea components and the SDC supplied with the Dualtrack System are exactly as described in
the relevant parts of the 440 System Manual and the 350 or 350 Powertrack Manual, except for those
differences listed in section B.1.2 "The Differences" on page
B.1.2 The Differences
Note the following important issues when you install the Dualtrack System:
1 Scope of Delivery
See section B.1.3 "Scope of Delivery" on page B-3
Dualtrack System.
2 Physical installation
See section 3.1.1 "Sub-sea Installation" on page 3-3
sea components of the Teledyne TSS 440 System.
See Chapter 3 "Physical Installation"
the sub-sea components of the 350 System.
You must take special precautions regarding the placement of the search coils when you install the
Dualtrack System on board an ROV.
See section B.1.4 "Physical Installation" on page B-5
must make when you install the Dualtrack System.
3 Electrical connection
To make the most efficient use of the ROV umbilical, the Dualtrack System uses only two wires for all
communications between the surface and the sub-sea installations. See sub-section B.1.6 "Electrical
B-2
NOTE
B-2.
for a list of the standard items supplied with the
of this Manual for instructions to install the sub-
of the 350 or 350 Powertrack Manuals for instructions to install
for a description of the special precautions you
© Teledyne TSS DPN 402196 Issue 4.1