Table of Contents
Advertisement
9 – Maintenance
Only a competent engineer who has received the relevant training and experience
should perform maintenance work on electrical equipment.
Power-off and isolate the equipment from the electrical supply before you work on
any equipment that uses a mains power supply. Arrange to discharge any power
supply storage capacitors safely.
Observe all relevant local and national safety regulations while you perform any
maintenance work on electrically powered equipment.
Do not connect the equipment to an electrical supply until you have refitted all
safety covers and ground connections.
9.2.1 Surface Display Computer
Many components within the SDC are susceptible to damage due to electrostatic
discharge. You must take precautions against such damage: These precautions
include the use of a grounded conductive mat and wrist-strap. Teledyne TSS will
not accept responsibility for any damage caused by failure to take such
precautionary measures.
9.2.2 Sub-sea Installation
Many components within the sub-sea pods are susceptible to damage due to
electrostatic discharge. You must take precautions against such damage: These
precautions include the use of a grounded conductive mat and wrist-strap.
Teledyne TSS will not accept responsibility for any damage caused by failure to
take such precautionary measures.
To complete the disassembly of the sub-sea pods you will need the following tools and facilities:
❐
A clean anti-static work area
❐
A 3mm hexagonal key
❐
A 2mm hexagonal key
9.2.2.1 Sub-sea Electronics Pod
(See drawing 490232 in Section
9-6
CAUTION
CAUTION
Chapter 10 "System
Drawings").
© Teledyne TSS
DPN 402196 Issue 4.1
Advertisement
Table of Contents
