Initial Configuration; Sub-Sea Electronics Pod; Figure 5-1: System Configuration Wizard - Teledyne 440 System Manual

within DeepView for Windows. Alternatively, you may connect a keyboard or mouse using either of the
two USB ports mounted on the front of the Panel PC.

5.2 Initial Configuration

Before you can use the 440 System for the first time you must configure the software. This procedure
can be enabled to run every time you open DeepView for Windows or if your setup is consistent it can
be disabled and accessed via "System Configuration Wizard" from the configuration menu when
DeepView is operational. The options that you are able to configure are the following:

Figure 5-1: System Configuration Wizard

5.2.1 Sub-Sea Electronics Pod

Define whether there is no SEP, a 440 or whether it is part of a Dualtrack System. This setting
determines the data format that DeepView for Windows expects to receive from the sub-sea
installation and sets the style of Run Window that the software will use to display the System
measurements.
There are three options for setting the SEP type:
❐
No SEP
Use this option to operate DeepView for Windows with no SEP connected. This might be nec-
essary, for example, if you wish to use DeepView for Windows to replay data on a separate
PC.
❐
440
Use this option to control a stand-alone 440 System.
❐ Dualtrack
Use this option to control a Dualtrack System comprising an interconnected 350 / 350 Power-
track and a 440 System controlled from the same SDC. You should use this option even if you
intend to use only one of the Systems during the survey.
DPN 402196 Issue 4.1 © Teledyne TSS
5 – Operating Software
5- 3