Adjustment Of The Lifting Draw-Bars Of The Hitch For A Single-Axle Semi-Trailer; Adjusting The Bowden Cable - Zetor FORTERRA HSX 100 2014 Operator's Manual

ADJUSTMENT OF THE LIFTING DRAW-BARS OF THE HITCH FOR A SINGLE-
AXLE SEMI-TRAILER
 Raise the hydraulic arms to the upper - transport position with the position control
selected and the vibration compensator off.
 Screw the nuts on the adjustable draw-bars towards the guiding pipe without any
play.
 Tighten the nuts by another 3.5 turns.
 Check whether it is possible to tilt off the supporting hooks freely.
 By lowering and repeated lifting of the hydraulic arms to the transport position check
whether the engine does not tend to "stall" at the idle speed - the relief valve of the
hydraulic pump must not be in operation.
 Then, lower the arms slightly.
ADJUSTMENT
F_02_142
224

ADJUSTING THE BOWDEN CABLE

It is performed if the carrier with the tow-
ing hook is in contact with the supporting
hooks. The Bowden cable must be ten-
sioned to avoid any play of the control
lever in the cab. Then, the cable is se-
cured against loosening with a nut.
FH12N019