Assembly Of The Wires (F5-K) - KEB COMBIVERT F5 Operation Manual

Control Circuit - STO
X2A
2.2.1. Assembly of the
wires (F5-K)
40
D, E Housings
X4A
X2B
Terminal Description
X2A
X2B
X3A
X3B
X4A
The STO control card uses a spring-loaded terminal strip. Use the following
instructions when wiring the control terminals
Required Tools:
Screw Driver SD 0.4 x 2.5 (DIN 5264)
1 Strip the line about 7mm
2 Plug screw driver into the middle square slot
3 Plug stranded wire into the round slot; be sure no
wire is seen from the outside
4
Remove screw driver and check if the wire is fixed.
Make sure that the stranded wire and not the
insulation is clamped
Control terminal strip
STO terminal block
Encoder Interface channel 1
Encoder Interface channel 2
HSP5 interface
G, H, R, U, W Housings
X4A