Setting Jumpers - Kontron PCI-946-1 Technical Reference Manual

PCI-946-1 and P3S440BX Technical Reference manual
3.2.
Downloaded from StockCheck.com

SETTING JUMPERS

JUMPER
W1
W2
W3
W4
W5
CONFIGURATION (Default Settings = *)
W1- Onboard Video
Enabled *
Disabled
W2, W3 - Serial Port 2 Termination
Termination Disabled *
W2, W3 - Serial Port 2 Termination
No Power (clear CMOS) *
There is a danger of explosion if the battery is
incorrectly replaced. Replace only with thesame
or equivalent type. Dispose of used batteries
according to the manufacturer's instructions.
W5- Power Fail Source Selection
External Power (through J14)
Onboard Battery *
To prevent the board from spurious PFI, the jumper cap
must always be installed at either 1-2 or 2-3 position.
3-2
off
on
off off
off
1 - 2
2 - 3