PCI-946-1 and P3S440BX Technical Reference manual
2.2.
The Ethernet interface is available through the J20 RJ-45 connector located on the edge
bracket.
The 10Mbps or 100Mbps (10Base-T, 100Base-Tx) network speed is automatically detected
and selected.
Related Jumpers
BIOS Settings
The 10Base-T interface uses UTP (Unshielded Twisted Pair) cables, category 5, 4 or 3 (5 is
better) while the 100Base-TX interface requires category 5 UTP cables.
Downloaded from StockCheck.com
ETHERNET
None
The onboard Ethernet feature is enabled by default.
To change settings, see Section 4.1.10: AWARD CMOS Setup Utility, Integrated
Peripherals Setup option
NOTE
To boot the board from LAN, the Boot from LAN First option must be
enabled using the
AWARD CMOS Setup Utility
Section 4.2.2).
The Ethernet controller has specific drivers for various operating systems and
software. To install these drivers, refer to the Utility Disk containing the
Ethernet drivers for your operating system (see Section 8 - Installing
Drivers).
, BIOS Features Setup (see
2-4