Table of Contents
Advertisement
2.8. VIDEO FEATURES
The CRT display connects directly to the J18 standard VGA 15-pin D-Sub connector
located on the edge bracket.
Related Jumpers
BIOS Settings
When the PCI INTA is assigned to the video controller (W9 shorted), the video controller
will issue an interrupt request signal when the end of an active field (VSYNC pulse to the
CRT monitor) is reached. By default the interrupt is disabled.
Downloaded from StockCheck.com
W1 to enable or disable the onboard video controller
W9 to assign the PCI INTA to the onboard video controller
Setup is described in Section 3.2 – Setting Jumpers
Refer to Section 4.1.6: AWARD CMOS Setup Utility, Chipset Features Setup for RAM
cache and video BIOS shadow capabilities
2-17
Onboard Features
Advertisement
Table of Contents
