Table of Contents
Advertisement
PCI-946-1 and P3S440BX Technical Reference manual
BIOS Features Setup (Continued)
Report No FDD For
Win 95
Hard Disk Write
Protect
HDD S.M.A.R.T.
Capability
Delay For HDD (Secs)
OS Select For DRAM
> 64MB
Gate A20 Option
Security Option
Diskette Access For
Boot Up NumLock
Status
Typematic Rate
Setting
Typematic Rate
(Chars/s)
Typematic Delay
(msec)
Comport
Speed
Parity
Data
Stop
Downloaded from StockCheck.com
BIOS
Setup
Option
Defaults
Defaults
No
No
Dis.
Dis.
Dis.
En.
0
0
Non-
Non-
OS/2
OS/2
Norm.
Fast
Setup
Setup
All
All
All, Supervisor
On
On
Dis.
En.
30
30
250
250
1
1
Auto
Auto
38400, 57600,
None
None
8
8
1
1
Possible
Settings
Yes, No
Select Yes to release IRQ6 when the system contains no floppy
drive, for compatibility with Windows 95 logo certification. In the
Integrated Peripherals screen, select NO on the Onboard FDC
Controller option.
En./Dis.
When Enabled, this option will not permit writing to the hard disk.
When Enabled, the Self-Monitoring, Analysis, and Reporting
En./Dis.
Technology (S.M.A.R.T.) features of the HDD are supported.
S.M.A.R.T is used for prediction of device degradation and/or
faults.
0-15
This number of seconds inserted prior to HDD initialization. 0 is
disabled.
Non-OS/2,
Select OS2 only if you are running OS/2 with greater than 64MB of
OS/2
RAM.
Normal, Fast
When Fast, enables fast switching of Gate A20 via the 440BX
chipset, instead of the keyboard controller.
Setup, Normal
If you have set a password, select whether the password is
required every time the system boots ("System" option), or only
when you enter Setup ("Setup" option).
When this option is set to Supervisor and the Security option to
System, all floppy disk accesses (read/write) are limited to the
Supervisor (supervisor password required).
On, Off
Control the state of the NumLock key when the system boots.
When set to "On", the numeric keypad generates numbers instead
of controlling cursor operations.
En./Dis.
When Disabled, the following two items (Typematic Rate and
Typematic Delay) are irrelevant. Keystrokes repeat at a rate
determined by the keyboard controller in your system. When
Enabled, you can select a typematic rate and a typematic delay.
6-30
When the typematic rate setting is Enabled, you can select a
char/sec.
typematic rate (the rate at which characters repeat when you hold
down a key).
250-1000 ms
When the typematic rate setting is Enabled, you can select a
typematic delay (the delay before keystrokes begin to repeat when
you hold down a key).
VT100 Settings
1,2
Use this option to select which COM port will be used for VT100
Auto, 2400,
9600, 19200,
Select the baud rate of COM port. used in VT100 mode.
115200
None, Odd,
Mark, Even,
Use this option to select the parity.
Space
7, 8
Use this option to specify the number of data bits being used.
1, 2
Use this option to specify the number of stop bits being used.
4-8
Description
Advertisement
Table of Contents
