Table of Contents
Advertisement
Downloaded from StockCheck.com
PCI-946-1 and P3S440BX Technical Reference Manual
F.2 GENERATE AN EMERGENCY FLOPPY DISKETTE :
F.2.1 Use a system that has a 1.44 Mbytes floppy drive A.
1.
Insert the Kontron Emergency Diskette in drive A:
2.
Copy the two files WDISK.COM and EMERDISK.TEK from drive A: to your
hard drive (those files are available on Kontron's CDROM).
3.
Insert a DOS formatted floppy diskette in drive A.
4.
At the DOS prompt of your hard drive (same path of the two files WDISK.COM
and EMERDISK.TEK), type WDISK EMERDISK.TEK then press Enter key.
5.
The program may display one of the following messages:
F.1.1.1 "Emergency Code transferred"
The emergency diskette has been successfully created. Take the appropriate actions
and restart from the step 4) when you see the following messages.
F.1.1.2 "Write to disk failure!"
Verify if your floppy diskette is write-protected.
F.1.1.3 "The file to program in flash was not found"
F.1.1.3.1
Be sure that EMERDISK.TEK file is in your current
path.
"Unable to read the binary file" or "Unable to close the opened file"
Possible floppy diskette corruption or bad data transfer between floppy disk and
host system.
F.1.1.4 "Unable to allocate a memory block of 256 Kbytes"
F.1.1.4.1
Not enough memory to run the WDISK program.
F-2
Advertisement
Table of Contents
