PCI-946-1 and P3S440BX Technical Reference manual
2.7.
2.7.1. Floppy Disk Drives
Two floppy disk drive units can be connected to the board through the J6 Floppy Disk
connector using a standard IBM 34-pin flat ribbon cable. An 18" floppy disk cable is
available from Kontron: part number 150-051.
Related Jumpers
BIOS Settings
The floppy disk cable is illustrated below:
Downloaded from StockCheck.com
STORAGE DEVICES
None
To define the Floppy Disk installation, refer to Section 4.1.4: AWARD CMOS Setup
Utility, Standard CMOS Setup option
To enable/disable the system to boot from the floppy disk, refer to Section 4.1.5:
AWARD CMOS Setup Utility, BIOS Features Setup option
2-12