Table of Contents
Advertisement
3.1.
SETTING JUMPERS
3.1.1. Jumper Description for the
VT-100 Mode (1-2)
Download Mode (3-4)
Board Configuration
CompactFlash Setting
Onboard Battery
Remote Reset
SCSI Termination
Onboard Video
Serial Port 2 Termination
PCI-MXS64GX
C
Description
When enabled, allows VT100 or ANSI terminal
connection
When enabled, allows data serial download from
a remote computer.
Defines if used with Front Access or Rear
Access
Use this connector to setup the CompactFlash
device in Master or Slave configuration.
Connects or Disconnects the battery to/from the
board circuitry.
To select Serial Port 1 or Serial Port 2 as a
source for the remote hardware reset.
Use this jumper to disable SCSI termination or
select the termination control method from
Software Controlled and Hardware Controlled
options.
Use this jumper to enable or disable the onboard
video feature.
Use these jumpers to connect or disconnect the
termination resistors on/from Serial Port 3 when
set for RS-422/RS-485 operation mode 0.
3.1
W1
W2
W3
W4
W5
W6
W7
W8, W9
Advertisement
Table of Contents
