Internal Jumper Setting - Kontron 104 User Manual

V Panel 104 / 121 / 150 / 170 / 190
Connector Interface
J3 Serial port COM3
J4 Serial port COM4
J6 Backlight interface
J12 Advanced power button interface
J13 External battery connector
J15 Internal Fieldbus interface
J16 Floppy disk drive interface
J17 Secondary IDE Compact flash
J18 Primary IDE Connector UDMA33
J21 IrDA/FIR connector
J24 PCI extension card
J25 PCMCIA
J26 Internal HDD power interface
J29 4-5 wire Tochconnector
J30 DMC touchcontroller interface (option)
J31/J32 Internal USB interfaces
J34 Speaker interface
J36 ATX Power button

3.3 INTERNAL JUMPER SETTING

To identify the jumper location please look to the board layout in Fig.3.2. All
described functions refers to the implemented baseboard.
3.3.1 Backlight supply voltage
Setting
1-2 (default)
2-3
3.3.2 Voltage supplied to display
Setting
1-6 (default)
2-5
3-4
3.3.3 Address range NVSRAM Switch DIP1
Setting SW1 DIP1
OFF
ON
*TO ENABLE THE NVSRAM DIP8 ON SW1 MUST BE SET TO OFF. IF SJA1000 CHIP SIS POPULATED DIP2 ON SW1 MUST BE SET TO OFF.
12
Backlight supply voltage
12V
5V
Display supply voltage
3V
5V
12V
NVSRAM address
CC000 – CFFFF (Hex)
D0000 – D7000 (Hex)
©
Copyright Kontron Embedded Computers GmbH
User Manual
J5
6 5 4
J8
1 2 3
SW1
1