Customizing The Board; Processor; Backup Battery - Kontron PCI-946-1 Technical Reference Manual

Table of Contents

Advertisement

3.5.

3.5.1. Processor

The PCI-946-1 SBC is shipped with the PPGA Celeron Processors running at 300, 366 or
433, MHz and future processors as technology evolves. It is equipped with a passive heat
sink that provides adequate cooling in a 150LFM airflow environment.
The P3S440BX SBC is shipped with the FC-PGA Pentium® III Processors running from
600 to 700 MHz and future processors as technology evolves. It is equipped with a passive
heat sink that provides adequate cooling in a 150LFM airflow environment

3.5.2. Backup Battery

An onboard 3.6V lithium battery is provided to backup BIOS setup values and the real time
clock (RTC).
When replacing, the battery must be connected as follows:
Downloaded from StockCheck.com

CUSTOMIZING THE BOARD

CAUTION
Since CPUs are very sensitive components, particular attention should be
given while installing a processor on the board. Improper installation may
damage the board and/or the CPU
Before installing a processor on your board, you must contact our
technical support for the installation procedure
WARNING
Danger of explosion if battery is incorrectly replaced
Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's
instructions.
3-13
Software Setups

Advertisement

Table of Contents
loading

This manual is also suitable for:

P3s440bx

Table of Contents