Table of Contents
Advertisement
CONTROLLER / USER INTERFACE
This chapter shows you how to set up your system for operations and also
provides an introduction on how to use the software and keypad keys.
The following topics are included:
System Start-up
Set-up Key
Analog Key
Alarm Key
System Start-up
To begin using the CG1000, follow these steps:
1.
Plug the power cord into the power entry module on the back of the
analyzer.
NOTE
2.
Plug the power cord into the appropriate AC power outlet.
3.
Turn on the analyzer by pressing on the side of the power switch
marked 1. The power switch is located on the back of the analyzer.
4.
Adjust the flow of the sample gas to the desired level (see Chapter 3
for flow requirements).
5.
Allow the analyzer to warm up for at least one hour.
6.
Set up your alarms, analog outputs, and serial communications. See
If the analyzer is a 230-volt analyzer, the power cord must be changed
to the proper type to match your country and/or electrical code. All
analyzers are shipped with a U.S. 120-volt plug and "har" European
power cord. The European cord will have a label stating "not for
North American usage."
Controller / User Interface
|
4-1
Advertisement
Table of Contents
