T0 Motor Parameters (Group P9) - V&T E5 Series User Manual

6.T0 Motor Parameters (Group P9)

P9.00
P9.0T
P9.0T
P9.03
P9.04
P9.0T ~ P9.04 are used to set the motor parameters according to motor nameplate.
P9.05
P9.06
P9.07
P9.08
P9.09
P9.T0
P9.TT
P9.TT
P9.T3
P9.T4
P9.T5
It determines the key motor parameters affecting the running control through implementing the motor
data identification. These motor parameters will be stored automatically after completion of motor data
identification process till the parameter is changed or another motor data identification.
The process of motor data identification is described as follows:
Input P9.00 to P9.04 properly in accordance with the motor nameplate, P0.T5 motor rated frequency,

P0.TT motor rated voltage, maximum output frequency P0.TT and the accelerationTdeceleration time
P0.08 and P0.09 properly.
Select the motor data identification selection P9.T5:

T: Motor data identification at standstill. After setting P9.T5 to T, press RUN key on the operation
panel to measure the motor parameters P9.06 ~ P9.08 automatically, and P9.T5 will be restored to
0 automatically after completion.
T: Complete motor data identification. After setting P9.T5 to T, press RUN key on the operation panel
to measure the motor parameters P9.06 ~ P9.T4 automatically, and P9.T5 will be restored to 0
automatically after completion.
Note:
 If the motor can be disconnected from the load, complete motor data identification (P9.T5=T) should
be selected, or motor data identification at standstill should be selected only. Make sure that the motor
96
E5 Series High Performance Universal Inverter
Reserved
Motor poles
Motor rated speed
Motor rated power
Motor rated current
No-load current I0
Stator resistance RT
Stator leakage inductance LT
Rotor resistance RT
Mutual inductance LT
Magnetic flux saturation coefficient T
Magnetic flux saturation coefficient T
Magnetic flux saturation coefficient 3
Magnetic flux saturation coefficient 4
Magnetic flux saturation coefficient 5
Motor data identification
Chapter 6 Parameter Descriptions
User's Manual
0 ~ T(0)
T ~ TT8(4)
0 ~ 30000 rpm (T500rpm)
0.4 ~ 999.9 kW (Factory)
0.4 ~ 999.9 kW (Factory)
0.T ~ 999.9 A (Factory)
0.000 ~ 65.000
0.0 ~ T000.0 mH (Factory)
0.000 ~ 65.000
0.0 ~ T000.0 mH (Factory)
0.00 ~ T00.00 % (Factory)
0.00 ~ T00.00 % (Factory)
0.00 ~ T00.00 % (Factory)
0.00 ~ T00.00 % (Factory)
0.00 ~ T00.00 % (Factory)
0 ~ T(0)
Ω
(Factory)
Ω
(Factory)