V&T E5 Series User Manual page 116

E5 Series High Performance Universal Inverter
PA.T6
PA.T7
PA.T8
PA.T9
These parameters are used to select various actions when some faults occur. When these faults occur
under some special circumstances, can only output alarm signal but not stop even shield the fault.
Ones place, tens place, hundreds place and thousands place displayed from PA.T6 to PA.T9 can be set:
0: Fault is not shielded, output fault signal and coast to stop.
If the fault occurs, output to motor is cut off, the motor coast to stop, the fault code is displayed on the
operation panel, if multi function output terminal function is set to "T4", the output is enabled.
T: Fault is not shielded, output alarm signal but continue to run.
If the fault occurs, continue to run, the fault code is displayed on the operation panel, if multi function
output terminal function is set to "T5", the output is enabled.
T: Fault is shielded, not output fault or alarm signal, continue to run.
The fault is completely shielded, the fault code will not be displayed on the operation panel, and
whatever multi function output terminal function is set to "T4" or "T5", the output is disabled.
Ones place
Tens place
Hundreds place
Thousands place
Ones place
Tens place
Hundreds place
Thousands place
Ones place
Tens place
Hundreds place
Thousands place
Hundreds place
Thousands place
Note:
To change factory setting, please contact the distributor or manufacturer.
Faults shield and alarm attribute setting T
Faults shield and alarm attribute setting T
Faults shield and alarm attribute setting 3
Faults shield and alarm attribute setting 4
PA.T6 Faults shield and alarm attribute setting T
Motor or motor cable is short circuited to ground
Power supply is switch off during running process
Power supply is abnormal
Output phase loss
PA.T7 Faults shield and alarm attribute setting T
EEPROM fault
Pre-charging contactor fault
Temperature sensor abnormal
Encoder disconnection
PA.T8 Faults shield and alarm attribute setting 3
+T0V output error
Analog input error
Motor over temperature (PTC)
Communication fault T(operational panel 485)
PA.T9 Faults shield and alarm attribute setting 4
Ones place Communication fault T(terminal 485)
Tens place Software version compatibility
Reserved
Reserved
Chapter 6 Parameter Descriptions
User's Manual
0000 ~ TTTT(00T0)
0000 ~ TTTT(00T0)
0000 ~ TTTT(T000)
0000 ~ TTTT(000T)
103