Tt Setting Process For Constant Pressure Control - V&T E5 Series User Manual

6.TT Setting Process for Constant Pressure Control

Motor data identification (For details,
refer to the parameter of P9.T5)
P0.03=T (Process close loop )
H0.00=T (Constant pressure control)
H0.04=0 (pressure setting is H0.05
Setting pressure upper limit H0.0T and
Setting close loop main feedback
channel (refer to parameter PT.05)
Setting close loop relative parameters
(refer to parameters in group P8)
Setting run command channel
Run command: Operation panel
Setting P0.07 running direction
Y
Setting Acceleration and deceleration
H0.TT to H0.TT
Setting
Sleep and wake-up according to
P4.09 to P4.T4
Setting H0.30 to T sleep and wake-up
Setting force wake-up function, setting
multi-function input terminal function to
Setting sleep status indication, setting
multi-function output terminal function
to "3T: sleep status indication"
E5 Series High Performance Universal Inverter
START
Pressure setting is analog?
N
digital setting)
lower limit H0.03
Y
Setting P0.06=0
time auto switch?
N
pressure?
Y
according to pressure
Setting H0.3T to H0.34
"3T: force wake-up"
END
Chapter 6 Parameter Descriptions
Y
Setting H0.0T to H0.04
according the actual needed
N
Run command: Terminal
Y
Setting P0.06=T
Setting terminal FWDTREV function
(For details, refer to the description of
P5.00 to P5.06)
N
Setting H0.30 to 0
sleep and wake-up according
to frequency
Setting H0.06 to H0.09
User's Manual
N
Run command: Communication
Setting P0.06=T
For details, refer to the description of
Appendix Modbus communication
protocol
121