V&T E5 Series User Manual page 88

E5 Series High Performance Universal Inverter
The following table lists the multi−function digital input terminal functions:
Setting
value
00 Jog forward
0T Jog reverse
0T Forward (FWD)
03 Reverse (REV)
04 Three−wire control
05 Pulse frequency DI input ( X7TDI)
06 Multi−step digital voltage terminal T
07 Multi−step digital voltage terminal T
08 Multi−step digital voltage terminal 3
09 Multi−step frequency terminal T
T0 Multi−step frequency terminal T
TT Multi−step frequency terminal 3
TT Multi−step frequency terminal 4
T3 AccelerationTdeceleration time terminal T
T4 AccelerationTdeceleration time terminal T
T5 Clear UPTDN regulation value
T6 Terminal UP (frequency increase)
T7 Terminal DN (frequency decrease)
T8 Acceleration and deceleration is prohibited
T9 External fault input
T0 Fault reset (RESET)
TT Run pause
TT Run is prohibited
T3 Stop via terminal
T4 Coast to stop via terminal
T5 Stop via terminal with DC braking T
T6 Emergency stop T (fastest stop)
00: Terminal jog forward input
0T: Terminal jog reverse input
0T: Terminal run forward input (FWD)
03: Terminal run reverse input (REV)
The functions of above items 0 to 3 are only enabled when the run command reference channel is
terminal (P0.06=T). Terminal run command and jog run command should be interlocked.
04: Three−wire control
It is only enabled in the terminal run command reference mode (P0.06=T). Refer to parameter P5.TT.
05: Pulse frequency DI input (only available for X7TDI terminal)
When the pulse frequency DI input acts as the reference (e.g. P0.04=4 or PT.0T=4), this function
must be selected for the X7TDI terminal.
Function
Chapter 6 Parameter Descriptions
User's Manual
Setting
value
T7 Stop via terminal with DC braking T
T8 Counter input
T9 Counter reset
30~3T Reserved
3T Force to wake-up
33~46 Reserved
47 Single phase pulse input for closed loop control
48 Run command is changed to operation panel
49 Run command is changed to terminal
50 Run command is changed to communication
Changeover between process close loop control
5T
and open loop control
5T Main frequency reference is changed to digital
53 Reserved
54 Main frequency reference is changed to AIT
55 Main frequency reference is changed to AIT
56 Main frequency reference is changed to AI3
57 Main frequency reference is changed to DI
58 Auxiliary frequency reference is changed to NONE
59 Reserved
60 Auxiliary frequency reference is changed to AIT
6T Auxiliary frequency reference is changed to AIT
6T Auxiliary frequency reference is changed to AI3
63 Auxiliary frequency reference is changed to DI
64~66 Reserved
67 Process closed loop output forced to 0
68 PID positive logic or negative logic selection
69~98 Reserved
Function
75