V&T E5 Series User Manual page 103

Figure6−T7 AOT Characteristics Curve−Kx+b
Note:
When the analog output both gain and bias are set to negative, the output will be limited to 0V.
P7.T0
This parameter determines the maximum frequency output by YTTDO. Refer to P7.0T for details.
P7.TT
This parameter determines YT and relay output signal type selection (level or pulse).
P7.TT
P7.T3
P7.T4
P7.T5
P7.T6
P7.T7
The parameters of terminal action delay time both on the level output and the pulse output are enabled.
The parameters of pulse width only for pulse signal.
Yi on behalf of YT,YT and relay terminal, in order to keep the waveform consistent before delay and after
delay, need to ensure that the output signal width> Yi terminal delay setting, if the output signal width <Yi
terminal delay setting, the signal will be ignored.
90
E5 Series High Performance Universal Inverter
YTTDO maximum output pulse frequency
Output signal type selection
P7.TT Output signal type selection
YT terminal
Ones place
0:Level signal
Tens place Reserved
Relay terminal
Hundreds place
0: Level signal
YT output function action delay time
YT output pulse width
YT output function action delay time
Reserved
Relay output function action delay time
Relay output pulse width
Chapter 6 Parameter Descriptions
User's Manual
Figure6−T8 AOT Characteristics Curve−Kx+b
T:Pulse signal
T:Pulse signal
0.T ~ 50.0 kHz (T0.0 kHz)
000 ~ T0T (000)
0.0 ~ 999.9 s (0.0 s)
0.0 ~ 999.9 s (0.0 s)
0.0 ~ 999.9 s (0.0 s)
0.0 ~ 999.9 s (0.0 s)
0.0 ~ 999.9 s (0.0 s)
0.0 ~ 999.9 s (0.0 s)