Multi-Function Output Parameters (Group P7) - V&T E5 Series User Manual

6.8 Multi-Function Output Parameters (Group P7)

P7.00
P7.0T
P7.0T
P7.03
P7.04
YT, relay terminals: multi-function digital output.
YTTDO: multi-function digital output or high-speed pulse output (0 ~ 50kHz).
AOT and AOT: multi-function analog output. 0 ~ T0V or 0 ~ T0mA can be selected by jumper.
The definition table of multi-function digital signal output is as follows:
Setting
0 Signal indicating that the inverter is running (RUN)
T Frequency level detection T output(FDTT)
4 Inverter or motor overload pre−alarm(OL)
6 Stop due to external fault input (EXT)
8 Frequency reach lower limit(FLL)
T0 Preset counting value reached
TT Reserved
T4 Fault output
T6 Reserved
T8 Continuous running time reached
T0 Output XT
TT Zero current detection arrival (relative to motor)
T4 Run command direction instruction
3T Sleep status indication
00: Signal indicating that the inverter is running (RUN)
The signal is enabled when the inverter is running.
0T: Running frequency arrival output (FAR)
When the deviation between the output frequency and the reference frequency is in the range of
P7.T9 (running frequency arrival detection level), the signal is enabled. Refer to P7.T9 for details.
0T: Frequency level detection T output (FDTT)
When the output frequency is higher than P7.T0 setting, the signal is enabled. When the output
frequency is less than P7.TT setting, the signal is disabled. Refer to P7.T0 ~ P7.TT for details.
03: Frequency level detection T output (FDTT)
When the output frequency is higher than P7.TT setting, the signal is enabled. When the output
frequency is less than P7.T3 setting, the signal is disabled. Refer to P7.TT ~ P7.T3 for details.
86
E5 Series High Performance Universal Inverter
YT output function selection
YTTDO output function selection
Relay output function selection
AOT output function selection
AOT output function selection
Function
Chapter 6 Parameter Descriptions
User's Manual
Setting
T Running frequency arrival output(FAR)
3 Frequency level detection T output (FDTT)
5 Under voltage (LU)
7 Frequency reach upper limit(FHL)
9 Frequency reach 0 Hz (still output at stop status)
TT Designated counting value reached
T3 Ready for operation (RDY)
T5 Alarm output (only alarm but not stop)
T7 Accumulative running time reached
T9 Output XT
TT Reserved
T3 Stop command (still output in stop status)
T5 Running status direction instruction
T6~3T, 33~47: Reserved
00 ~ 47(00)
00 ~ 7T(0T)
00 ~ 47(T4)
48 ~ 7T(48)
48 ~ 7T(49)
Function