V&T E5 Series User Manual page 94

E5 Series High Performance Universal Inverter
P5.TT
P5.T3
When the pulse signal counting of the terminal input complies with the preset condition, the terminal Yi
will output corresponding instructions. The setting procedures are as follows:
T. Setting one of P5.00 to P5.06 (digital terminal function XT to X7) to "T8: Counter input", and setting
P5.TT and P5.T3, such as P5.TT=4 and P5.T3=8 .
T. Setting one of P7.00 to P7.0T (YTTYTTrelay output terminal function) to "T0: Reach preset counting
value", and the action sequence is shown as OutT in the following figure. Effective level will be output
when the counting value is between the values of P5.TT and P5.T3.
3. Setting one of P7.00 to P7.0T (YTTYTTrelay output terminal function) to "TT: Reach designated
counting value", and the action sequence is shown as OutT in the following figure. Effective level will
be output when the counting value reaches the value of P5.T3 and maintain till the counting value
changes.
Note:
 P5.TT cannot be set to a value of higher than P5.T3, and the counter pulse signal frequency range is
0Hz to T00Hz. The voltage range is T4V
 Setting one of P5.00 to P5.06 (digital terminal function XT to X7) to "T9: Counter reset", and reset the
counting value when this terminal function is enabled.
Figure6−T9 Schematic diagram for the preset and designated counting value
Preset counting value setting
Designated counting value setting
±
T0%.
Chapter 6 Parameter Descriptions
User's Manual
0000 ~ 9999(0000)
0000 ~ 9999(0000)
81