Operation Example - V&T E5 Series User Manual

4.8 Operation Example

In the following example, the displayed parameters in stop status is reference frequency, the factory
setting is 50.00Hz. The underscored line in the figure means the bit that is being edited.
4.8.T Restore to Factory Setting
For example, setting P0.0T=5: Restore all the parameters in zone P to factory settings.
4.8.T Setting Frequency
For example, setting P0.05=T5.00Hz.
4.8.3 Setting Password
For example, setting user password P0.00 to 0003.
4.8.4 Password Verification
Assume that the parameters are protected by password and the password is 3. If the password protection
is not enabled, you can press ESC+PRG+
perform the password verification according to the following process:
Note:
If you use RS 485 communication mode to perform password verification, please refer to the appendix A.
4.8.5 Clear Password
For example, clear the user password P0.00.
40
E5 Series High Performance Universal Inverter
∧
Chapter 4 Operation Panel
to enable the password in last example of P0.00. You can
User's Manual