V&T E5 Series User Manual page 48

4.4.3 Menu Mode
Value setting
(P0.02)
0
T
T
3
Basic menu mode bASE

Basic menu includes all the parameters mentioned in this user's manual. Except for the special
descriptions, all the descriptions of this manual are in this menu mode.
Fast menu mode FASt

Fast menu includes some common parameters and you can start the inverter by setting only a few
parameters so as to realize the fast application.
Non−factory setting menu mode ndFt

This menu mode is used to search for the parameters different from the factory settings for the
convenience of understanding the parameter setting.
Last changed T0 parameters menu mode LASt

This menu mode is used to display the last changed T0 parameters and P0.0T. If the password
protection is set, only P0.00 and C0.00 can be viewed. The last changed T0 parameters, P0.00 and
P0.0T can be viewed only when correct password is entered into P0.00.
Method of back to basic menu

T. By setting parameter P0.0T to 0, then the menu returns to basic menu mode after bASE is displayed.
T. By using M key: Define the function of multi−function key M as menu switchover function, and then
press this key to switch the menu mode. Refer to table 4−T for the methods of using multi−function key
and meanings of MULTI indicator.
3. By pressing ESC for a long time: Press ESC and do not release it for more than 5s, then the menu
returns to basic menu mode after bASE is displayed. If bASE is not displayed, this means the menu is
already in basic menu mode.
E5 Series High Performance Universal Inverter
Menu mode name
Basic menu mode
Fast menu mode
Non−factory setting
menu mode
Last changed T0
parameters menu mode
Chapter 4 Operation Panel
User's Manual
Visible parameters
See the table 5.T for all
parameters
Quickly display the menu
parameters in common use
Only display the parameters
different from factory settings
Display the last changed T0
parameters and P0.0T
Operation
panel display
bASE
FASt
ndFt
LASt
35